Solutions to common faults of slitting machines

Solutions to the common faults of the slitting machine
The use of sponge slitting machines often causes tendon bursting. When we encounter such problems, what methods should we adopt to solve them and minimize our losses?
Common problems and solutions of slitting machine:
1. When we collect the 1000-meter roll with multiple sponges with bursting tendons, when the rolling is about 300 meters long, before the bursting tendons show up, we replace it with a film roll that has no problem and continue winding. In this way, the ribs cannot be displayed, and the stretching and deformation of the film will not be caused, thereby improving the yield.
2. When we cut the sponge with only two sides with bursting ribs, when the thousand-meter roll is received at about 300 meters, before the bursting ribs show up, reverse the rolls on the two sides of the winding shaft; When they reach about 700 meters, they should be reversed again, so that the finished rolls won’t have bursting tendons. Thereby reducing loss and improving yield.
3. Generally, tendon bursting occurs only in extruded products, and tendon bursting rarely occurs in dry compounded products.
4. Sprinkle a small amount of hygienic smooth powder on the slitting machine when it is rewinding, which can also relieve the tendon bursting phenomenon.

主图_4


Post time: Nov-29-2022