Slitting machine lubrication and maintenance

1. Regularly check the brake pads of the unloading reel and waste shaft, and replace them immediately if the brake pads are found to be excessively worn.
2. When the transmission chains and gears of each part are short of oil, they should be filled with butter immediately.
3. The internal gears of the gear pack have been lubricated with butter when the machine leaves the factory, and need to be lubricated every six months.
4. Regularly check the lubrication of the reducer. If the reducer is found to be short of oil, immediately add gear oil.
5. Regularly check the lubrication of the bushing and shaft on the coiling shaft. When lubricating, it should be lubricated with non-corrosive lubricating oil.
6. Check the air source processor for abnormalities every month. When there is a lack of oil, use non-corrosive lubricating oil for lubrication.
7. Do not wipe the embossing wheel, rubber wheel, and take-up shaft with corrosive chemicals.
8. Regularly check whether the screws of each part are loose.

主图_4


Post time: Nov-30-2022