Operating Instructions for Hot Slitting Machine

1. Arrange the knives
(1) Press the forward and backward knife button on the control panel to press down the hot knife and fit it with the roller shaft.
(2) Open the mechanical door cover on the right, mobilize the hot cutter and press down the screw so that the blade just touches the roller shaft.
(3) Stick the tape measure on the roller shaft and place it above the hot cutter.
(4) Start from the fuselage or the first hot knife on the left, loosen the fastening screw, and align the blade with the scale on the ruler (starting from 0 or an integer). Tighten.
2. Feeding
(1) Loosen the fixing screw on the right side of the feeding shaft, and take out the tight cloth shaft sleeve.
(2) After the bearing is pushed out to the left, string the rolled cloth.
(3) After inserting the tight cloth bushing, put it back to its original position.
3. Put away the fabric
(1) According to the working path of the eager slitting machine, pull the fabric upward until it reaches one of the receiving shafts.
(2) Turn on the edge-to-edge switch on the control panel, and make the electric eye align with the edge of the cloth.
4. Sleeve paper circle
(1) Remove the fabric receiving shaft and place it on the fixed frame of the paper discharge circle of the workbench.
(2) Prepare the paper circle for rolling the cloth strips.
(3) Referring to the tape measure, stagger the receiving paper rings according to the order of the cutter size and insert them into the two receiving shafts respectively.
(4) After stringing the latex strip into the groove of the cloth receiving shaft, push it upward from the shallow end of the groove to tighten the paper circle.
5. Heating
Press the heating on button to start heating, and the thermostat is powered on to set the temperature. Control panel instructions.
6. Temperature and speed setting
(1) According to different fabrics, set the temperature, generally between 300-380 degrees.
(2) When the temperatures displayed by the three thermostats all reach the set data and are relatively stable, it is advisable to set the trial cutting speed frequency to [5.00].
7. Trial cutting
Press the switch of the forward and backward knife, and try to cut the cloth by hand. When the cut length can touch the fabric receiving shaft, press the switch of the forward and backward knife to stop.

主图_4


Post time: Dec-22-2022