Maintenance method of needle detector

Some faults will occur during the use of the needle detector. Most of the faults and problems will be worry-free as long as the equipment is maintained regularly. Here are some tips for you:

1. Cleaning tools: Find a clean towel, wet it with water and wring it out until the water cannot be wrung out.

2. Cleaning of the surface of the conveyor belt: Note that the sensitivity of the needle detector should be adjusted to the lowest level before cleaning. If the needle detector has B/C mode, please adjust the needle detector to C mode, so as not to affect the next step due to high sensitivity cleaning work. Then straighten the towel and press it properly on the surface of the conveyor belt, start the actuator, and make the actuator run more than five times (the purpose is to clean the pollutants on the surface of the conveyor belt, the method can be flexibly applied by yourself), then wash the towel and twist it Dry, repeat this step to wipe the conveyor belt again until there is no obvious contamination on the surface of the conveyor belt;

3. Clean the back of the conveyor belt: Then wash and wring the towel, pass the towel through the bottom of the conveyor belt from the lower part of the device, straighten the towel, and pull the towel to the front of the conveyor table, grasp both ends of the towel, and start the device. Run for several weeks. Since the bottom of the conveyor belt is the dirtiest place, multiple wipes are required. After each operation for several weeks, the towel must be pulled out and washed again to repeat the above steps.

4. How to judge the cleaning effect: After the needle detector conveyor belt has gone through the above two cleaning steps, adjust the sensitivity to level 8 or the highest sensitivity, start the device, let the device run, if the device runs smoothly and the metal position indicator light of the probe When it is off, put in clothes without any metal impurities at this time, and the clothes can pass through the needle detector channel smoothly, that is, the conveyor belt is cleaned successfully!


Post time: Dec-02-2022