Cutting and unloading steps of the Hot slitting machine

RH-400A hot cutting and slitting machine is especially suitable for cutting chemical fiber fabrics, silk, geotextiles and plastic braids because it adopts the automatic temperature control heating method of the cutter.  let’s talk about the cutting and blanking steps of the eager slitting machine.
The eager slitting machine starts the cutting steps:
1. Press the switch of the forward and backward knife, and close the knife to cut the material.
2. During the operation process, pay attention to whether the cut cloth can meet the requirements; whether the tightness of the material is moderate; whether the winding is neat.
3. After the material cutting operation is stable, the speed can be adjusted and the temperature should be adjusted appropriately.

Eager slitting machine stop blanking steps:
1. When there are about 2 meters left in the fabric, turn off the potentiometer switch on the speed control frequency, and press the forward and backward knife switch to stop.
2. Cut off the uncut fabric at the end, and stick the cloth strip to the cloth roll with adhesive tape to prevent it from falling apart.
3. Remove the fabric receiving shaft, place it on the unloading rack of the workbench, turn it downward with a little force to loosen the rolled cloth strip, and pull out the latex strip.
4. Push out the cloth roll, fold it and pack it.
The above are the basic steps of cutting and unloading of the eager slitting machine. The above procedures must be followed in daily operation, otherwise it is easy to cause failure and damage to the cloth inspection machine.

主图_1


Post time: Dec-06-2022