1. Do not tamper with the electrical equipment in factories and workshops. If the electrical parts of the equipment and tools used by oneself fail, they should not be repaired without permission, and they should not be operated with faults, and should be repaired by an electrician immediately.
2. The distribution boxes, distribution boards, knife switches, push button switches, sockets, pins, and wires that you often touch and use must be kept intact and safe, and must not be damaged or expose live parts. If there is any failure, notify in time Electrician repairs.
3. Mobile electrical appliances in the factory, such as floor fans, portable grinders, hand drills and other electric tools must be installed with leakage protection switches to implement stand-alone protection. The leakage protection switch should be checked frequently, and the trip should not be less than once a month. If it fails, it should be replaced immediately. After the fuse is blown or the leakage switch trips, the cause must be found out, and power transmission can only be resumed after troubleshooting.
4. The shell of the electrical equipment used must be protectively grounded or connected to zero according to the relevant safety regulations. For grounded or grounded facilities, checks should be made frequently. It is necessary to move some electrical equipment that is not fixedly installed, and the power supply must be cut off before moving. At the same time, the wires should be tidied up and not dragged around on the ground to avoid wear and tear. information
5. Cherish power resources, develop good habits of using electricity safely and saving electricity. When leaving for a long time or not using it, you must ensure that the power supply (especially electric heating appliances) is cut off before leaving.
6. Be familiar with the location of the main air circuit breaker (commonly known as the main gate) of your production site (such as construction site, workshop, office, dormitory, etc.).
When purchasing fabric inspection machines, entrepreneurs should try their best to buy machines with higher efficiency and energy saving. During use, try to ventilate the workshop well, start production when the temperature is low in the morning and evening, and develop the habit of turning off the electricity and electrical appliances. Keep electrical appliances in a standby state for a long time. It is best to unplug electrical appliances and sockets that are not in use to ensure safe use.
Post time: Dec-08-2022