14-point operating specification for fabric slitting machine

Fabric slitting machine operating procedures:
1. Power transmission Turn on the air switch in the control cabinet, the power indicator light of the fabric slitting machine is on, pay attention not to touch the terminal with your fingers, be careful of electric shock, which will endanger safety.
2. Upper curtain roll Open and guide the safety clip, hang the curtain roll, close the safety clip, separate the curtain and tape, and wind the curtain onto the take-up drum.
3. Manually transfer the adhesive tape to the manual, turn forward and jog the guide, manually drag the adhesive tape, and pass through the correction roller, tension roller, brake roller, and drive roller.
4. Thread drawing Cut the rubber strip with scissors according to the size of the rubber strip to be produced, then draw the thread and fix it on the thread-drawing roller.
5. Upper coiling roller Remove the square shaft at the end of the coiling shaft, install 30 nylon reels, then install the upper shaft, open the coiling safety chuck, and install the coiling shaft. The operation of coiling 1 and coiling 2 is the same.
6. Tape the head Stretch the rubber strip to a suitable position, wind the rubber strip on the reel, and pay attention to the consistent length of the rubber strip to keep the tension of the rubber strip consistent.
7. Adjust the tension Adjust the coiling tension to 6.5-10, and adjust the unwinding tension to 10-15. Note that as the coiling diameter increases, the coiling tension increases appropriately to ensure that the tension of the rubber strip is consistent.
8. Adjust the coiling speed Adjust the coiling speed within the required range. Note that the coiling speed should not be too high when starting to avoid deviation correction and tracking errors. It can be adjusted to 20 and then increase the speed after starting.
9. Start the fabric slitting machine After the above operations are completed, press the start button, and after one or two rotations, observe whether the reel rubber strip is offset or not. If so, stop winding, adjust the position, and continue to rotate. At the same time, pay attention to the position of the thread head to adjust the start and stop of the thread to prevent the thread from being broken or pinched.
10. Adjust the tightness of the coiling rubber strip. If the rubber strip is loose, it is generally due to the thickness of the rubber strip, resulting in a smaller coiling diameter. You can add a plastic pad to increase the diameter, so as to ensure the tension and other glue. The article agrees.
11. Stop the fabric slitting machine when the coiling is completed. When the coiling diameter reaches 160mm, stop the machine.
12. Unload the product Cut off the adhesive strip, loosen the safety chuck, lift down the take-up shaft, take the lower shaft, unload the product, pay attention to separate the products in time, do not stack them together, and prevent them from sticking together.
13. Prepare for the next coiling
14. If the fabric slitting machine is not used for a long time, please turn off the main power of the machine


Post time: Dec-13-2022